draw distance

link 17.10.2006 22:24

Subject: draw distance

Recheck the feed wheels and the draw distance of the
side lays. 10
Correct draw distance: 5 to 8 mm 10
Adjust the spring pressure while checking the draw of the
side lays. 10
Also, check that the paper is properly gripped by the
swing grippers. 10
(For details, refer to page 7-21 “Adjusting the Side
Lays”.) 10
2 mm Allen key, 10 × 13 open ended spanner

http://foto.mail.ru/inbox/zinger_01/1/113.html

freelancer_06 ✉

link 17.10.2006 22:28

здесь это не комп термин из википедии про прорисовку

вот что-то похожее
http://www.print-media-academy.com/www/html/en/binaries/files/downloads/profi_tipp_2_

Should creases develop, this may also be the fault of incorrect machine settings
– most likely on the sheet-feeder. Among the reasons creases may form are
incorrectly set or jamming front lays, side lays that draw with too much force, a
hold-down device that has been set too tightly, or an air-blast that is too strong.
An incorrect air-pressure setting at the point of sheet transfer may also contribute
to the formation of creases. Further sources include poorly functioning or
dirty grippers, which warp the sheet, as well as a printing pressure between the
rubber and the impression cylinder that is set too high,

freelancer_06 ✉

link 17.10.2006 22:39

это что ли вытяжка , протяжка какая-то?

freelancer_06 ✉

link 17.10.2006 22:48

http://www.freepatentsonline.com/5267728.html

You need to be logged in to post in the forum

Get short URL