 |
|
Subject: Start locking time gen. Engine governor-internal start sequenceTo program a start sequence, the following functions must be set: ... Start locking time Спасибо! |
|
Контексту маловато: ИМХО Это может быть и 1. start lock time = время блокировки пуска (двигателя например) и 2. Start locking time = начальное время синхронизации... Учитывая, что Engine governor это регулятор оборотов двигателя, а start sequence = последовательность пуска/запуска...?? О чем хоть речь идет?? |
| по смыслу: время/длительность блокировки (функционирования) аппарата на время пуска |
|
General information Most of the parameters which are related to the start sequence cannot be changed at user level 1a. However, they are described here to understand the start sequence. The start sequence for the various applications • Marine • Rail • Genset • C&I is worked through very differently. For this reason, the engine governor provides a basic program that has to be adapted to the respective application. If even more advanced functions are required, the ECU-internal program part can be switched off for the start sequence. In its place, a start sequence must then be implemented in an external, intelligent assembly (e.g. in the SAM or a LOP control stand, see above). Settings To program a start sequence, the following functions must be set: • Saved or non-stored start • Type of stop • Monitoring of coolant temperature • Prelubrication • Binary output for starter • Permissible time until starter speed is reached • Permissible time until release speed is reached • Permissible time until idle speed is reached • Start locking time • Manual turning Мне кажется, здесь речь не о синхронизации. ... |
|
link 8.01.2012 18:47 |
| Та шо вы заморачиваетесь! Время блокировки пуска. Кому надо - поймет. Если каждую фразу так мусолить, без штанов ходить будешь.... |
| Спасибо! |
| You need to be logged in to post in the forum |