Subject: set to IN electr.eng. Сабж. Что такое IN?5.1.2 Switches & Jumpers: S1 Address Mode: When the switch is set to DISABLE, the Module Number cannot be changed from a master on the data highway. When set to ENABLE, the Module Number can be changed for the next ten minutes from a master on the data highway. During this time the ADDRESS light is on. S2 RS485-120: When the jumper is set to IN, the RS-485 line is terminated by a 120 ohm resistor. Only the last Control Module on the data highway should be set to IN.
|