|
Subject: gate drive circuits el. Не силен я в электронике. Не подскажете , как перевести gate drive circuits ?A Fault signal from the auxiliary gate drive circuits IC1, IC2 and the commutation gate drive circuits IC6, IC7 is generated if too high collector-emitter voltage is detected at the IGBT transistors. If this happens the gate drive circuits shut down the gate pulses while going into a Fault state. The Fault signal is carried through connector CN1:10 to the processor on the Control board 20AP1. The Fault state is reset by a Reset signal from the processor on the Control board 20AP1.
|
