Cylindrical offset
In LC-200R, an offset value can be added to measured values of cylindrical specimens.
Set the offset before starting measurement without fail.
The offset scale is HRC ( diamond indentator/150kg ( 1471N) ) only
Select the offset selection screen (Z-9) from the measuring screen (Z-1).

key (Cylindrical Offset)（Z-9-1）
Selects the cylindrical offset
After selection, the screen transfers to the cylindrical offset screen (Z-10)
Select either mm or inch by mm/inch setting in the screen.
If mm is select, offset is done according to JIS standards
If inch is selected, offset is done according to ASTM standards.
The cylinder diameter is not converted between mm and inch by calculation
An inputtable range is displayed at the bottom part of the screen (Z-10-8)
Decide the numeric value by ▲ or ▼ key on the upper or lower side of each **digit.(Z-10-3, 5 )

Уже задавала этот вопрос насчет digit
Мне сказали вариант разряд - тут как-то разряд не идет.
Цифра?
Спасибо.