 |
|
link 9.08.2011 7:58 |
|
Subject: W.I.R. Помогите, пожалуйста, расшифровать аббревиатуру в сабже. Контекст: электрическая схема системы управления flame heater'ом. Идут сигналы:W.I.R. 'A' FIRE DETECTED Спасибо! |
|
а эти надписи на одном прямоугольничке схемы? схему-то покажите |
|
link 9.08.2011 9:17 |
вот кусочек: чертежи все однотипные, сверху идет такой ряд, обозначения сигналов, например: pump A start, gas leak detected, tank level low low, burner flame off и т.п. |
|
так это чертёж а описание где? в описании обязательно есть расшифровка требуйте от заказчика если не дали |
|
link 9.08.2011 10:04 |
|
блииин, как глючит форум... пока загрузится, кругосветку можно сгонять... В общем, это Walk In Room. Еще пример: walk in room door closed. Но вот как это назвать?? |
|
walk-in есть перевод холодильное помещение дверь холодильного помещения закрыта |
|
walk-in = refrigeration или "с отдельным входом" |
|
Walk-ins are built of modular panels, and are insulated with foamed-in-place polyurethane insulation. Each panel is designed to ensure ease of installation, long term reliability and high insulating efficiency. All panels are manufactured with male and female mating rails to ensure proper alignment during installation. The polyurethane insulation wraps around the return bend metal seams on both section to create a lightweight panel of exceptional strength and durability. All panels are a full four (4) inches thick and provide a superior insulating value. The foamed-in-place cam locking fasteners ensure an airtight seal for maximum energy efficiency. Panel gaskets around the outer perimeter of the panel are continuous, without cuts or breaks at corners. The gasket design provides a foamed-in-place gasket as an integral part of the panel. Gaskets cannot fall off or pull off during shipment or installation. Panels lock together tightly to assure an energy efficient walk-in. Edge caps for ends of floor and ceiling panels are foamed-in-place rather than overlapped or mechanically fastened. Edge caps cannot come loose, and they stay in place through the life of the walk-in. Interior and exterior surfaces are 26 gauge corrosion-resistant stucco embossed coated steel. Models supplied with a floor will include a smooth aluminum interior floor surface. Insulation: Panels are four (4) inches thick, metal clad and foamed-in-place with HFC-134a polyurethane insulation which is CFC and HCFC free. Each Walk-in Room is equipped with a 26” wide door. The height of the door opening varies with the series of Walk-in ordered. The 6' unit has a 59” high door, the 6’7” high has a 66” high door and the 7'6" Walk-ins have a 78” high door. The door is self-closing, flush mounted and constructed to incorporate heavy duty, molded ABS breaker which is permanently foamed-in-place. Each unit can be supplied with a variety of Walk-in Options. |
| You need to be logged in to post in the forum |