If the overall dimension entered by the user is less than the minimum value, the minimum value will be automatically considered without any indications or data correction during the parameter table entry
phase. It is therefore not necessary to measure the dimensions of the disk cutter but
just those of the head, on a head with vertical disk cutter.
In the case of tilting tools to be used with different slant angles, it is advisable to enter
the dimension the head may assume as the angle varies from minimum to maximum
value in continuous mode.

заранее спасибо

кроме
тех [размеров] у головки, [что есть на] головка с вертикальным отрезным диском