Plug Params tab, Equipment screen:
 Die Warm After (s)
 Die Cold After (s) - die - трафарет
 Cold Ramp Adjustment Rate (s)
 Maximum Load At Start (%)
 Maximum Load During Run (%)
 Maximum Load Debounce (s)
 Average Load At Start (%)
 Average Load During Run (%)
 Average Load Deviation At Start (%)
 Plug Deviation Load At Start (%)
 Plug Deviation Load During Run (%)
 Two Motor Deviation Load At Start (%)
 Two Motor Deviation Load During Run (%)
 Run 2nd Plug Routine If Plug Within (s)
 Run 2nd Plug Routine If Load Not Low In (s)

Наиболее интересным является, как связать Plug Params tab
и что понимать под Run 2nd Plug Routine If Plug Within (s), а также
Cold Ramp Adjustment Rate (s)

Run 2nd Plug Routine If Plug Within (s)
Выполнить вторую подпрограмму , если имярек находится в пределах (диапазоне) (с)